Click here to view our full heat exchange product offerings.
All Categories > Heat Exchangers > Armstrong Heat Exchangers > Armstrong Model # W-44-4  
Download PDF Download PDF     Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Armstrong Model # W-44-4, Armstrong Heat Exchanger






Specifications  · JFD Heat Exchangers

Specifications

JFD Cross Reference
BEU04-48-4

Service
Liquid to Liquid

Shell Size (IPS)
4 in

Tube Length
48 in

Type
4-Pass

Heating Surface (4-pass)
6.4 ft²


JFD Heat Exchangers
For over 20 years J.F.D. Tube & Coil Products, Inc. has been designing and fabricating new shell & tube heat exchangers, as well as direct replacement and duplicate exchangers.

J.F.D. designs and builds all its Heat Exchangers to ASME Section VIII, Division 1 requirements, as well as per TEMA B, C, & R standards. J.F.D. does all fabrication in house so you get the quality performance you expect in your application. Our experience has helped customers solve difficult fluid flow, heat transfer, and corrosion problems with sophisticated material selection and creative fabrication designs.

Our design / fabrication capabilities include, but are not limited to:
  • New & Replacement Units
  • 4" Nominal to 60" Nominal
  • Shell & Tube Type Exchangers
  • Double-Wall Tube Heat Exchangers
    • Type BEM/BEU
    • Double Wall Vented Tube Type
  • Double Pipe Type Exchangers
  • Pressure Vessels
  • Aftercoolers
  • Replacement Fabricated Heads & Nozzles
  • Tanks & Weldments
  • Standard & Specialty Alloys
Forward the model / part number of your existing exchanger, and JFD can cross reference.
JFD Can Cross Reference the Following Manufacturers:
  1. Adamson
  2. American Standard
  3. A. O. Smith
  4. Armstrong
  5. Bell & Gossett
  6. Cemline
  7. Graham
  8. ITT Standard
  9. Old Dominion
  10. Patterson-Kelley
  11. Reco
  12. Taco
  13. Thrush
  14. Yula
J.F.D. standard heat exchangers ship 5-6 weeks after receipt of purchase order and final drawing approval. RUSH / EMERGENCY SHIPMENTS AVAILABLE for new heat exchangers and retube / repair orders.

J.F.D.’s engineering and sales staff will assist you with designing and sizing new units, We can fabricate to your specifications, cross-referencing your current make & model or taking on-site measurements (in the Tri-State and New England areas).

Ship your existing heat exchanger to J.F.D. for a diagnostic and we will advise on how to proceed. Freight and inspection fees may apply.